Jeti Advance 18 Pro SB

18 amp Speed controller for brushless motors with switching BEC to power up to 5 servos at 5.5V when using 2-4 Li-Polymer or A123/LiFePO4 cells. Fitted with an arming switch.

Jeti Advance Pro controllers denoted as SB (Indicating a Switching BEC) can power your receiver and servos even when using higher voltage flight packs. This 18-amp controller is useful in models with up to 5 analog servos operating from 2-4 cell Li-Poly batteries, where a controller with a linear type BEC would be unlikely to manage the demands of 5 servos, particularly when operating from a 4-cell lipo battery.

Advance Pro controllers are ready-to-use straight from the box with no programming required. The default settings are as follows: -

• Brake: off | medium | hard
• Timing: auto | high | low
• Acceleration: high | medium | low
• Cut-off voltage (Li-Po): 2.8V | 3.0V | 3.2V (per cell)
• Cut-off voltage (Li-Fe): 2.2V | 2.5V | 2.8V (per cell)
• Cut-off type: hard | slow-down
• Motor rotation: right
• Battery type: Nixx | Lixx | LiFe

All settings can be adjusted via your transmitter or for maximum simplicity use the Advance Pro Programming card, available separately, which is also compatible with the old Advance Plus range of controllers.

Just solder the three motor wires to your motor or choice of connector and add your favorite battery connector.

With two-year warranty.

Made in Czech Republic.