The Jeti Advance 40 Pro SB is a 40 amp speed controller with built-in switch-mode BEC, supplying a 5.5V power-supply at up to 5A for your receiver and servos and supporting up to six analog servos.
This controller supports a higher cell-count than the standard Advance 40 Pro: Up to 16 NiXX cells, Up to 6 Li-Poly cells and up to 7 A123/LiFePO4 cells.
Female gold connectors are already fitted to the motor side of the controller and the mating male halves are included in the packaging with heat-shrink to fit to your three motor wires.
Advance Pro controllers are ready-to-use straight from the box with no programming required. The default settings are as follows: -
- Brake: off | medium | hard
- Timing: auto | high | low
- Acceleration: high | medium | low
- Cut-off voltage (Li-Po): 2.8V | 3.0V | 3.2V (per cell)
- Cut-off voltage (Li-Fe): 2.2V | 2.5V | 2.8V (per cell)
- Cut-off type: hard | slow-down
- Motor rotation: right
- Battery type: Nixx | Lixx | LiFe
All settings can be adjusted via your transmitter or for maximum simplicity use the Advance Pro Programming card, available separately, which is also compatible with the old Advance Plus range of controllers.
Just solder your choice of connector to the pre-tinned battery wires.
Compatible with LiPo, A123 and NiCd/NiMH batteries.
With two-year warranty.