The Jeti Eco 40 brushless speed controller for electric motors is a simple and economical speed controller supporting 2-3 cell lithium polymer batteries (or 6-12 NiCd/NiMH cells) and offers control of the most common programming options through simple jumper-plug selection.
The Jeti Eco 40-amp controller features a built-in linear BEC. This provides the receiver and servos with a 5.0v power-supply directly from your 2 or 3 cell Li-Po battery, eliminating the need for a separate receiver battery. The Jeti Eco 40 controller is fitted with an arming switch, however, we recommend to always disconnect batteries when not in use.
Jeti Eco brushless motor controllers also feature a power cut-off system, which cuts power to the motor of your RC plane when the voltage of your lithium battery indicates that it is nearly depleted. This feature conserves power for your receiver and servos, allowing you short bursts of motor power and full control of your radio controlled model to bring it down safely.
Jeti 'Eco' speed controllers are programmed with special software, which allows precise control of brushless motor timing automatically. No programming is required to achieve the correct timing for your brushless motor.
Built-in temperature overload protection cuts power to your brushless motor, should the temperature of the controller exceed 100°C. This feature is designed to prevent failure of the controller due to over-heating. Always ensure a good supply of air flowing over the controller to maintain an even temperature during flight.
The Jeti Eco 40 supports four modes of operation, selected using the include jumper plug: -
- Mode 1:
- Battery Type: NiCd/NiMH Batteries
- Brake: OFF
- Cut-off Type: Slow down
- Cut-off Voltage: 5 Volts or 0.7v/cell
- Mode 2:
- Battery Type: NiCd/NiMH Batteries
- Brake: ON
- Cut-off Type: Stop
- Cut-off Voltage: 5 Volts or 0.7v/cell
- Mode 3:
- Battery Type: Li-Po/Li-Ion Batteries
- Brake: OFF
- Cut-off Type: Slow down
- Cut-off Voltage: 6 volts for 2-cells, 9 volts for 3-cells
- Mode 4:
- Battery Type: Li-Po/Li-Ion Batteries
- Brake: ON
- Cut-off Type: Stop
- Cut-off Voltage: 6 volts for 2-cells, 9 volts for 3-cells
The Jeti Eco 40 speed controller for brushless motors is supplied with a two-year manufacturers warranty on the basis that they are used according to the manual and there is no mechanical damage.
Connectors are not included.
Always disconnect your battery when not in use.
Made in Czech Republic.