The Jeti Duplex MUI 150 is a voltage and current sensor, compatible with all Jeti Duplex receivers and expanders, suitable for measuring currents up to 150A and voltages up to 60V.
Using this sensor it is possible to view in realtime, your battery pack voltage, motor run time and the capacity drawn from your flight battery as well as the actual current being drawn by your power system. You can also set alarms for: -
- Low voltage
- High amps
- Consumed capacity (mAh)
The MUI 150 current sensor should be connected between the power system's battery pack and the speed controller, in order to provide a pass-through to measure the current draw of your power system. A single yellow wire serves this purpose.
Two additional wires are used to measure pack voltage, which extend approximately 300mm from the unit.
An audible alarm can be configured via the Jeti Box to provide an alert when the flight battery voltage drops below a configurable minimum or when the current draw exceeds a configurable maximum. An alarm can also be configured for the battery capacity. The alarm sound is emitted from the duplex transmitter module.
Please note, the maximum current capability of this sensor is 150 amps. This sensor is not required to view the voltage of the Duplex receiver system, which is provided by all Duplex receivers, without the need for an additional sensor.
No connectors are included with the sensor.
With English instructions.
Technical Details for Jeti Duplex 2.4EX MUI 150 sensor