2 x Male Deans Ultra Plug

Two genuine male Deans Ultra Plugs complete with heatshrink.

Less resistance than the equivalent length of 12-gauge wire.

Soldering instructions: -
1. Use a HOT soldering iron (700°F minimum), with a 1/8" tip.
2. Place one piece of tubing onto each wire.
3. Do NOT plug together during soldering.
4. Strip 3/16" and pre-tin.
5. Pre-tin connector pins.
6. Solder according to +/- markings on plug.
7. Slide tubing over solder joint and heat-shrink

When using Deans Ultra plugs for battery to speed controller connections, always use the Female half on the battery, to reduce the chance of short-circuits.

When using Deans Ultra plugs for speed controller to motor connections, use the Female half on the speed controller.