3D Printed Quadcopter

The Mezon 240mm DIY quadcopter frame is a bare kit made from brightly-coloured 3D printed plastic parts that weighs just 156 grams (Approx. 5.5oz). The Mezon is very easy to build and includes all hardware fittings required to build the frame, however no electronics/motors/wiring or flight controller are included. This is a great cheap quadcopter and its very simple, yet strong construction and its low price and make it the ideal candidate when you just want a cheap quad frame either to test some gear or to fill some downtime between more serious frames on the building board.

Mezon 240 features: -

• Simple construction
• Bright colours
• 2 FPV camera holders included to accommodate different types of FPV camera
• Integrated holders at rear of top plate for 3mm receiver antennae tubes
• Can be easily repaired with cyano glue

Recommended setup: -

• T-Motor Air 40 motors
• 3s Li-Po Battery (1300mAh-1550mAh)
• Naze32, BetaFlight, RaceFlight or similar flight controller

Made in Czech Republic.